Need More Power

Since my last post, I've fitted a DCC chip to the 14xx (quite simple and apologies for not adding pictures).

However as it's my shortest loco I've found it having issues going over the pointwork on the inner track, such as stalling when on the point blades between the main rails and the electro frogs, after a bit of testing and installing extra wire at the toes of the points I've found that what is causing the problem.

It would seem that for some reason the point blades on the inner loop isn't picking up power off the main rails as they do on the outer loop, to bypass this I'll add extra droppers into the point as shown in the image below.

 In the image the red rails are fed from the red wire of the dcc bus and the black from the black wire of the dcc bus, the blue section is fed from the point motor to switch the polarity depending on the position of the blades. The additional wires to add extra power to the points will be added where the small circles are, this should then solve my problems, however this can be reminded before installing the points by adding a bridging wire in a similar fashion to how I made my curved points live (see this post)but obviously placing the wire before the gap on the point to avoid shorting the track out.