DCC Decoder v3 Firmware
Well I have been working on my arduino based DCC Decoded and am proud to announce that I have been able to create a firmware update Link Removed . This enable a couple of features on my pcb's which have had slight rewiring due to my silly errors. I still need to correct a few errors (such as a recently occurring servo chatter) but most seems to work fine. New Features include push button programming (in a similar fashion to train tech signal where you press a button and it takes the next address thats pressed) LED to show when in programming mode EEprom utilization to remember address when powered off Changes to come Push button adjustment of servo movement limit (may require new PCB version or control board) PCB Changes Added Reference ground Changed pushbutton resistor connection Removed 3 unusable pin headers Corrected resistors outlays for 1/4w resistors Added GND and 5v layers If anyone would like a copy of my new pcb and the updated list of components requi